Choosing a scope base and rings for the Howa 1500

|Howa Rifles Europe
Scope mounted on a Howa chassis rifle

Half of the "my rifle does not group" e-mails we receive end at the scope mounts. Here is how to get them right on a Howa 1500 the first time.

Which base fits

The Howa 1500 short and long action use the same footprint as the Weatherby Vanguard, so any base listed for either fits. Two-piece Weaver bases are light and cheap and perfectly adequate for a hunting rifle. A one-piece Picatinny rail is stiffer and gives you more ring positions; it is the right choice for a long-range or chassis rifle. The Mini Action has its own base; do not buy a short-action base for it. The Superlite ships with a Picatinny rail already fitted.

Zero or 20 MOA

A 20 MOA canted rail tilts the scope down so that more of its adjustment range is available for long shots. For hunting inside 300 metres you do not need it. For 6.5 Creedmoor at 800 metres you do. If in doubt, a 20 MOA rail costs nothing in practice with a modern scope.

Rings

Match the ring height to the objective: a 50 mm objective on a Sporter barrel usually needs medium rings, a 56 mm objective high. Buy the ring height that keeps the objective bell a few millimetres above the barrel, no more. Lower is more repeatable and more comfortable.

Torque values

  • Base screws to receiver: 2.5 to 3 Nm (22 to 26 in-lb), with a drop of blue thread locker.
  • Ring clamp to rail: 5 to 7 Nm (45 to 65 in-lb), no thread locker.
  • Ring cap screws: 1.7 to 2 Nm (15 to 18 in-lb), cross pattern, even gaps both sides.

Use a torque wrench. Over-tightened ring caps crush scope tubes; over-tightened base screws strip the receiver threads, and that is not a warranty matter.

What we sell

Howa factory bases and rails are in our accessories collection. If you tell us the scope you have, we will tell you the ring height.

Back to the Journal